REQUIRED EMPLOYEE SUPPLIED TOOL LIST
APPRENTICE LEVEL:
- Electricians Tool Belt (No Pouch Sling types)
- 9" Side cutters (Lineman's Pliers)
- 8" Diagonal cutters ("Dikes")
- 8" Needle-nose Pliers
- Wire Stripper & Cutter - 10-20AWG Solid
- Aviation snips, Offset snip -straight cut
- Adjustable Wrenches
- (1) 6" Size, (1) 10" Size
- Slip Joint Pliers (Tongue and Groove)
- (1) Pair of 430 (10") size, (1) Pair of 440 (12") size
- Common Screwdrivers Assorted
- (1) 1/4" Common (Large), (1) 3/16" Common (Medium), (1) 1/8" Common (Trim)
- Phillips Screwdrivers Assorted
- (1) #1 Size Phillips, (1) #2 Size Phillips, (1) #3 Size Phillips
- Scratch Awl (Center punch)
- Electricians Hacksaw
- Jab "Keyhole" Drywall Saw
- Electricians or Utility Knife
- Claw Hammer (16-20oz)
- Tape Measure (25-30ft)
- 9" Magnetic Topedo Level
- Roto-split MC Cable cutting tool
- Flashlight
- Hex Key Folding sets
- (1) Metric set, (1) SAE Standard set
- 7 Piece Hollow Shaft Nut Driver Set
- (1) Metric Set, (1) SAE Standard set
- Voltage Tester (Non-Battery Powered)
- "Ideal Vol-Test" #61-065, "KLEIN AC/DC Voltage Tester" #ET60 or equivalent
- Cordless Drill Set - Impact Tool and Drill/Driver Tool w/ Batteries and Charger, 18V Min
- ANSI Rated Work Boots (Non-Steel toe) Composite Toe -OK
Professional Service is one of our nation's most honored and sought-after careers.
Work hard and take pride in your career as a service provider.
JOURNEYMAN LEVEL + (In addition to the apprentice level required tools)
- Fuse Puller
- Chaulk Box (Reel Line kit), laser line tool
- Plumb Bob or laser level
- Digital or Analog Multi-Meter, 600A, W/ Clamp and Probe Kit
- Mechanics Tool Set Metric and SAE with 1/4"-1/2" Drive Ratchets
- Knock-out Punch set 1/2" -2" Cut
- Slip Joint Pliers (Tongue and Groove)
- (1) Pair of 460 (16.5") size
- 100' Tape Measure
- NEC Code Book (Current Edition)
- Local Code Requirements (SA, Chapter X)
Any Additional Local Code Requirements
FSG SUPPLIED TOOLS:
PPE:
- Hard Hat
- Safety Vest
- Cut-Resistant Gloves
- Leather Gloves
- Safety Glasses
- Ear Plugs
- PFAS (Personal Fall Arrest System) consisting of Full Body Harness, Lanyard & SRL (Yo-Yo)
All equipment should be stored in a manner to not be damaged and the PFAS should be hung if possible. Lastly, PPE should be cleaned regularly and replaced when needed.
*Not required for Apprentices / Helpers with < 5 years experience in the electrical trade
I have read and understood the tool list requirements. I agree to acquire and maintain the tools listed above. I understand that my tools are my responsibility and are not covered by the company’s insurance. I understand that the required tools need to be available to me during all working hours and that they need to be in good and safe working order.